Dynatronix LT1200X SERIES Specifications download pdf (Page 29)

Smart LT Manual Dynatronix, Inc.

198-0853-02 Rev F Page 29 of 126

6.3. Unit Configuration

The “Unit Configuration Menu” is used to configure the power supply. Parameters in this menu

will generally be configured when a unit is installed and will not need to be changed after that.

Settings related to cycle control (current and voltage settings, RTC or ATC settings, etc) which

may require changes related to the process that is running are located in the “Unit Setup Menu”

(see 6.4.Cycle Control Settings for details regarding cycle control settings).

The “Unit Configuration Menu” can only be accessed when the power supply is first powered on.

The “Unit Configuration Menu” is password protected. The default password is “0000”. The

password can be changed from within the “Unit Configuration Menu”.

To enter the “Unit Configuration Menu” use the following procedure. See A.6.Unit Configuration

Menu for more information regarding navigation of the “Unit Configuration Menu”.

1) With the power supply powered off press and hold both encoder switches.

2) While still holding both encoder switches turn the power on.

3) Continue holding both encoder switches until the display shows “Unit” “CFg”, then

release the encoder switches.

4) The unit configuration password must be entered before access to the “Unit

Configuration Menu” is granted. The display shows “Unit CFg COdE” on the top

display and the default password “0000” on the bottom display. If the password has

not been changed from the default then press the voltage encoder switch to enter

the “Unit Configuration Menu”. If the password has been changed then the correct

password must be entered. Rotate the current encoder to adjust the selected digit

(blinking digit). Each press of the current encoder advances the selected digit.

Once the correct code has been entered press the voltage encoder switch to enter

the “Unit Configuration Menu”.

5) Once access to the “Unit Configuration Menu” has been granted the top display will

show “CFg” and the bottom display will show the selected sub menu. Rotating the

current encoder will change the sub menu selection. Pressing the voltage encoder

will enter the selected sub menu.

6) To exit the “Unit Configuration Menu” rotate the current encoder until the display

shows “CFg” “End”, then press the voltage encoder to exit the “Unit Configuration

Menu”. The power supply will restart into its normal mode of operation displaying

the last selected run screen.

6.3.1. Totalizer Configuration

The power supply contains a user configurable totalizer that accumulates amp time while the

power supply outputs current. The “Totalizer Configuration Menu” can be used to configure the

totalizer units and resolution as well as clear the totalizer.

The “Totalizer Configuration Menu” is accessed from the “Unit Configuration Menu” (see 6.3.Unit

Configuration). To enter the “Totalizer Configuration Menu” select the “tot” sub menu from the

“Unit Configuration Menu” and press the voltage encoder. The “Totalizer Configuration Menu” will

show “tot” on the top display and the selected sub menu on the bottom display. For more details

regarding “Totalizer Configuration Menu” navigation see A.6.1.Totalizer Configuration Menu.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 125 126

Comments to this Manuals

No comments

Dynatronix LT1200X SERIES Specifications Page 29

Comments to this Manuals

Related products and manuals for Power supply units Dynatronix LT1200X SERIES