Dynatronix LT1200X SERIES Specifications download pdf (Page 40)

Page 40 of 126 198-0853-02 Rev F

1) From the “Unit Configuration Menu” rotate the current encoder until the display shows

“CFg” “SyS”, and then press the voltage encoder switch to enter the “System

Configuration Menu”.

2) From the “System Configuration Menu” rotate the current encoder until the display

shows “SyS” “dFLt”, and then press the voltage encoder switch to enter the “Set

Defaults System Menu”.

3) The first screen in the “Set Defaults System Menu” shows “Set Unit dFLt” on the top

display and shows “yES” or “no” on the bottom display. Rotate the current encoder to

make a selection. Select “yES” to reset all settings to default values, or select “no” to

leave the settings unchanged. Press the voltage encoder switch to accept the

selection.

4) If “yES” was selected a warning screen is displayed. The warning screen shows

“CHng” on the top display and “ALL” on the bottom display. The warning message is

displayed for a short period of time and can be skipped by pressing the voltage encoder

switch.

5) After the warning message is displayed a confirmation screen is displayed. The top

display shows “CHng ALL to dFLt” and the bottom display shows the confirmation

selection. Rotate the current encoder to change the confirmation selection. Select

“yES” to reset all settings to default value or “no” to cancel. Press the voltage encoder

switch to accept the selection and exit the “Set Defaults System Menu” and return to the

“System Configuration Menu”.

6) From the “System Configuration Menu” rotate the current encoder until the display

shows “SyS” “End”. Then press the voltage encoder switch to exit the “System

Configuration Menu” and return to the “Unit Configuration Menu”.

7) If any settings were changed in the “System Configuration Menu” you will be prompted

to store the changes. Select “yES” to accept the changes or “no” to cancel the

changes. You must select “yES” to complete the reset to default values.

6.4. Cycle Control Settings

All cycle control settings are located in the Setup Menu. The Setup Menu can be accessed at any

time; however settings cannot be changed while the unit is operating. In addition the settings

cannot be changed while in remote control mode (RMT lamp is on). For details on accessing and

navigating the Setup Menu see A.5.Unit Setup Menu.

6.4.1. Manual Cycle Control

In manual cycle control the power supply output is enabled and disabled by the operate/standby

front panel switch, or the digital input (inhibit input), or through serial host port commands (see

8.0.Remote Operate/Standby Control for details on other methods of operate/standby control).

Once the supply is put into the operate state or the standby state it will remain in that state until it

is commanded to a different state or power is lost (see 6.3.4:Power On Configuration for details on

how to retain the operate state through a power off/on sequence).

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 125 126

No comments

Dynatronix LT1200X SERIES Specifications Page 40